Well let me show you more about my board.
There are marking lines for each sizes of tubing. That slot on top is very important to help avoid a big mistake.
The flattening ends need to face the same direction not at 90 degrees from each other, like above LOL.
Notice how I labeled the pipe.
Just use the slot and insert one end.
Place the opposite end in the press bench and squish.
Also there is a seam that runs from one end to the other. When you place the tubing in the press make sure that the seam is at a 45 degree angle or the seam will split.
That's it for today. I only messed up 3 tubes so far which means I'm 3 short so I better buy extras.
Notice how I labeled the pipe.
Also there is a seam that runs from one end to the other. When you place the tubing in the press make sure that the seam is at a 45 degree angle or the seam will split.
No comments:
Post a Comment